Linear
Connecting Linear to Arcus by Testsigma lets you attach a defect on a test case to a Linear issue, either one that already exists or one you create from Arcus.
Prerequisites
- An active Linear account with the necessary permissions.
Connect Linear
Section titled “Connect Linear”-
In the left navigation, go to Settings > Integrations.
-
Click Setup Integration next to Linear. The Linear Login page opens in a new tab.
-
Log in with your Linear credentials.
-
On the Requesting Access page, click Authorize.
Log a defect
Section titled “Log a defect”Log a defect from a test run with the Report a defect sheet. The sheet works the same way for every tracker. Only the fields that say where the issue goes, and the Linear fields under More Linear fields, differ. For the full procedure, including how to link an existing issue and how to report a defect from an automated run, see Defects.
-
In the left navigation, open Test Runs, then open a test run.
-
Open the test case and click Add a Defect, or click the defect icon on the test case’s row in an automated run. The Report a defect against sheet opens.
-
In Tracker, select Linear.
-
Select the Project and the Team. Only the Team is required, and Arcus fills it in from the project.
-
Check the Title and the Description, which Arcus writes from the test case, and set the Priority and the Assignee.
-
(Optional) Fill in More Linear fields: Status and Estimate, in story points.
-
Click Create defect. Arcus creates the issue in Linear and lists it under the test case’s Reported Defects.
To link an issue that already exists instead, click Link existing at the top of the sheet, pick the issues, and click Link defect. You can link one test case to several issues.
Was this page helpful?
Thanks for the feedback.